Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) - Manual (Page 113)

9300 Servo PLC
Appendix
3.5 System error messages
3−11
L
9300 Servo PLC EN 5.0
System error message Possible settings/response
· Lenze setting ü setting possible Available in
No. Display Source Meaning Code TRIP Message Warning FAIL−QS
P
Off Drive
PLC
Servo
PLC
ECSxA
Floating−point error (REAL) in:
x209 float Sys−T Internal System task 2) · ь ь ь ь ь
x210 float Cycl.−T Cyclic task (PLC_PRG, ID 1)
x211 float T Id2 Task with ID 2
x212 float T Id3 Task with ID 3
x213 float T Id4 Task with ID 4
x214 float T Id5 Task with ID 5
x215 float T Id6 Task with ID 6
x216 float T Id7 Task with ID 7
x217 float T Id8 Task with ID 8
x218 float T Id9 Task with ID 9
x220 NoT−FktCredit Internal Not enough technology units available in the
PLC · ь ь ь
x230 No Program Internal No PLC program loaded in PLC · ь ь ь
x231 Unallowed Lib Internal A library function has been called in the PLC
program which is not supported · ь ь ь
x232 NoCamData Internal Motion profiles (cam data) are not available · ь ь ь
Free CAN objects:
x240 ovrTransQueue Free CAN
obj. Overflow of the transmit request memory C0608 · ь ь ь 3) ь ь ь ь
x241 ovr Receive Too many receive telegrams C0609 · ь ь ь
Application memory (FLASH):
x250 2.Flash Err Internal Access not possible 1)
(FLASH memory defective or not available)
· ü
x251 AddData CsErr Internal Check sum error occurred when loading data
into the FLASH memory
x252 AddData DlErr Internal Error occurred when downloading data into the
FLASH memory (e.g. time−out)
x260 Err NodeGuard Node
guarding "Life guarding event": The PLC as a CAN slave
has not received any "node guarding" telegram
within the node lifetime of the CAN master. C0384 · ь ь ь 3) ь ь ь ь
x: 0 = TRIP, 1 = Message, 2 = Warning, 3 = FAIL−QSP
1) When the error has been eliminated: Deenergise the controller completely!
2) In DDS adjustable under Project W Exception response
3) Only with 9300 Servo PLC!