Outputs_aif3, 9300 servo plc, System blocks – Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) User Manual
Page 27: 2 outputs_aif3, 3 aif3_io_automationinterface (node number 43)
9300 Servo PLC
System blocks
2.3
AIF3_IO_AutomationInterface (node number 43)
2−13
L
9300 Servo PLC EN 5.0
2.3.2
Outputs_AIF3
This SB is used as an interface for output signals (e.g. setpoints/actual values) to attached fieldbus
modules (e.g. INTERBUS, PROFIBUS−DP).
·
The process image is
– created in the cyclic task in a fixed time interval of 10 ms.
– created in an interval task within the time set for this task.
– read at the beginning of the task and written at its end.
Tip!
Please observe the Operating Instructions for the attached fieldbus module.
Outputs_AIF3
Automation
Interface
...
Byte
1
Byte
2
Byte
3
Byte
4
Byte
5
Byte
6
Byte
7
Byte
8
...
16 Bit
LowWord
16 Bit
HighWord
16 Bit
16 binary
signals
16 Bit
16 binary
signals
AIF3_nOutW2_a
AIF3_nOutW1_a
AIF3_bFDO0_b
AIF3_bFDO15_b
AIF3_bFDO16_b
AIF3_bFDO31_b
16 Bit
16 Bit
AIF3_nOutW4_a
AIF3_dnOutD1_p
AIF3_nOutW3_a
Fig. 2−6
Outputs_AIF3