Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) - Manual (Page 2)

This documentation applies to the following Lenze PLC devices:
Type designation As from hardware version As from software version
9300 Servo PLC EVS93XX−xl 7A 8.0
9300 Servo PLC EVS93XX−xT 7A 8.0
What’s new?
Version Changes
1.4 07/2000 Revised edition for the 9300 Servo PLC as of software version V1.0
2.0 07/2001 Revised edition for the 9300 Servo PLC as of software version V2.0
3.0 01/2003 Revised edition for the 9300 Servo PLC as of software version V6.0
4.0/4.1 08/2006 Revised edition for the 9300 Servo PLC as of software version V7.0
5.0 10/2010 Revised edition for the 9300 Servo PLC as of software version V8.0
Important note :
The software is supplied to the user as described in this document. Any risks resulting from its quality or use remain the responsibility of the
user. The user must provide all safety measures protecting against possible maloperation.
We do not take any liability for direct or indirect damage, e.g. profit loss, order loss or any loss regarding business.
ã 2010 Lenze Drive Systems GmbH
No part of this documentation may be copied or made available to third parties without the explicit written approval of Lenze Drive Systems
GmbH.
All information given in this documentation has been carefully selected and tested for compliance with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not accept any responsibility or liability for any damage that may occur. Required
correction will be included in updates of this documentation.
All product names mentioned in this documentation are trademarks of the corresponding owners.
Version 5.0 10/2010