MTS Model FlexTest SE - Manual (Page 100)

Models FlexTest® IIm/GT/SE Controller Hardware
Sensor Cables
FlexTest GT Controller Connections 100
Sensor Cables
A typical system is provided with a standard set of sensor cables as specified on
the System Cable/Jumper Plug 493 Package Selection drawing (PN 700-000-
656). Refer to this drawing for the most current part numbers. Standard sensor
cables do not have ID modules.
Sensor cables with an ID module built into them are available as an option.
Sensor cables with ID modules use a system cable to bridge the sensor cable to
the appropriate connector on the rear panel of the chassis.
Sensor Cable Specifications
• 15 contact type D male EMI connector
• Backshell–EMI metallized plastic
• Cable type–For all applications including CE EMC Compliance, use MTS
cable material PN 050-530-101 (two 22 AWG twisted pairs with inner and
outer braided shield for the excitation and feedback signals, plus a twisted
quad for the ID signals, and a single wire for the shunt calibration signal).
• If purchased as an option, each sensor includes one cable with a transducer
ID module and a system extension cable. A system cable is required
between the transducer ID cable and the controller’s chassis.