MTS Model FlexTest SE - Manual (Page 86)

Models FlexTest® IIm/GT/SE Controller Hardware
Cable Part Numbers
FlexTest GT Controller Connections 86
HPU 505 or 24V PLC Pump (for more information see
“Hydraulic Configurations” on page 243)
039-713-
7XX 493.73 J25 039-713-301
HSM 298.11 on/off
HSM Proportional 298.12
HSM 290.xx/293.xx/294.xx high/low 039-701-
5XX
056-126-
4XX
039-701-
4XX 493.74 J28 N/A
Interlock—Test Enclosure 056-126-
3XX 493.74 J43 100-007-948
Interlock—Station per system 493.74 J43 100-007-948
Remote Station Control—with E-Stop 055-634-
2XX 493.71 J50 055-634-101
Remote Station Control—with Station Stop 055-634-
3XX 493.71 J50 055-634-101
Workstation Link (Ethernet cable) 051-996-
8XX
10/100 ‡ N/A
Remote Setpoint Adjust Control 100-051-058 493.40 J4–J7 N/A
* -XX specifies cable length. –01 through –09 represent 10–50 ft. in 5 ft. increments. Higher numbers
represent custom cable lengths .
† Jumper plugs are required if a cable is not installed.
‡ The connector is the 10/100 BaseT connector on the power PC module.
System Cables (part 2 of 2)
C ABLE D ESCRIPTION P ART
N UMBER*
M ODULE
C ONNECTOR
J UMPER P LUG†