Cabling for external command inputs, How to enable and run external command inputs, Cabling for external command inputs 210 – MTS Model FlexTest SE User Manual
Page 210: How to enable and run external command inputs 210
Advertising
Models FlexTest® IIm/GT/SE Controller Hardware
Cabling for External Command Inputs
FlexTest IIm Controller Connections
210
Cabling for External Command Inputs
Cabled properly, your FlexTest controller can receive programming from an
external controller.
How to Enable and Run External Command Inputs
To enable an external command source, perform the following:
1.
“Cable the controllers.”
on page 211.
2.
“Allocate external command resources in Station Builder.”
3.
“Adjust the command signal with Station Manager.”
4.
“Start the External Command.”
on page 212.
Advertising
This manual is related to the following products: