MTS Model FlexTest SE - Manual (Page 231)

J28 Hydraulic Service Manifold Connector
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest SE Controller Connections 231
Cable specification The J25 HPU and J51 Box In connectors are 15 pin type D male connectors.
• 15 contact type D female EMI connector.
• Cable—24 AWG, 10 conductor with braided shield with drain wire
connected to metallized plastic backshell to the chassis.
Jumper plug required
If connector J25 HPU is not used, you must install a jumper plug to maintain the
integrity of the interlocks. Use jumper plug PN 039-713-301 or jumper pins: 1–7,
2–3–5, 6–9, 8–10–11–12, 6-9.
For an electrical diagram of J25, see page 132 .
J28 Hydraulic Service Manifold Connector
See “J28 Hydraulic Service Manifold Connector” on page 134.