MTS Model FlexTest SE - Manual (Page 60)

Models FlexTest® IIm/GT/SE Controller Hardware
Installing the Handle Kit
Installation 60
7. Insert a Phillips screwdriver through the hole in the button (7) and lightly
tighten the screw (5).
8. Assemble the remaining handle kit components to the other handle side leg
(2) according to steps 1 through 7 and mount the side leg to the mounting
holes on the opposite side of the controller.
9. Insert a lock washer (10) and handle screw (11) through the mounting hole
at the end of one handle side leg (2) and lightly tighten to handle (12).
Repeat this step for the other handle side leg, then secure both screws (11).
(The mounting screw for the first handle side leg may have to be loosened
slightly to allow the second handle side leg to be mounted.)
10. Snap cover (13) in place over the handle screw (11) and lock washer (10).
11. Secure mounting screws (5) on each side of the controller.
12. Press in both buttons (7) and rotate the handle assembly. The assembly
should rotate up and down easily. When the buttons (7) are released, the
handle should lock into a detente position and remain there. If the handle
does not move easily, or if it does not lock into a detente position, an error
may have been made during the assembly. Take a small straight blade screw
driver and carefully remove the covers (13), loosen all screws and remove
the handle assembly from the controller. Reassemble the handle side leg
assemblies according to steps 1 through 7.