MTS Model FlexTest SE - Manual (Page 59)

Installing the Handle Kit
Models FlexTest® IIm/GT/SE Controller Hardware Installation 59
Handle Kit
1. Place one support arm (1) into one handle side leg (2), as shown in the
handle kit assembly figure.
2. Set one of the clips (3) in place over the slender, straight portion of the
support arm (1), just behind the circular end of the support arm.
3. Insert two washers (4) and a screw (5) through the mounting hole in the
handle side leg (2).
4. Insert a spring (6) and a button (7) into the handle side leg mounting hole,
over the screw (5) and washers (4).
5. Press the button (7) into the handle side leg, as far as you can and push a
ratchet (8) over the button (7) leg detentes, until it snaps into place over the
first set of detentes. Make certain the burred or sharper edges of the ratchet
are pointing toward the handle side leg.
6. Hold a ratchet housing (9) in place over the ratchet (8) and press the posts on
the back side of the ratchet housing (9) into the mounting holes on the side
panel of the controller.
1
2
3
4
5
6
7
8
9
10
11
12 (handle-not shown)
13