MTS Model FlexTest SE - Manual (Page 52)

Models FlexTest® IIm/GT/SE Controller Hardware
Chassis Installation Options
Installation 52
Rack mounting
requirements
When installing the chassis in an equipment rack allow a minimum of 2 in. (5.1
cm) on either side of the controller for air flow. There are no spacing
requirements for the top or bottom of the controller. If the equipment rack is
equipped with doors, allow adequate clearance for the front and rear of the
controller. The rear of the controller requires a minimum clearance of 6 in. (15.24
cm) to accommodate cables.
The chassis can be installed in any Model 490.8x console. Install the console
with the Model 493.02 Chassis Rack Mounting Kit (PN 100-063-209).
The rack mounting kit provides the hardware (L-shaped brackets) to support the
chassis and mounting screws to secure the chassis to the console rack.
Rack Mount Option
The Controller chassis is
designed to fit into a standard
electronics rack.