MTS Model FlexTest SE - Manual (Page 67)

Transition Module Connectors
Models FlexTest® IIm/GT/SE Controller Hardware Installation 67
Transition Module Connectors
Cable connections to external devices are made from the 497.01 chassis rear
panel connectors.
J101–J1601 System connectors J101 through J1601 (JX01) are 15-pin D-type connectors
located on the chassis rear panel. They connect either a valve driver to a
servovalve or a conditioner to a transducer. The cable that is plugged into these
connectors depends on whether a valve driver or a conditioner is installed in the
corresponding chassis slot location.
J102–J1602 Connectors J102 through J1602 (JX02) provide a second connection for dual
conditioners, dual valve drivers, or three-stage valve drivers. Each module has
four rear panel connectors associated with it (Jx01, Jx02, J2x, and J3x).
J21–J28 Rear panel I/O connectors J21 through J28 (J2X) are 15-pin D-type connectors
located on the chassis rear panel. They are used to connect either a valve driver to
D/A converters (command) or a conditioner to A/D converters (feedback).
J31–J38
Rear panel Aux connectors J31 through J38 provide the same signals as J21
through J28 and are used to connect external readout devices.
J41 and J42
Rear panel communication connectors J41 Com In and J42 Com Out are
associated with the communication module installed in slot B. This connector
allows serial communication with a host computer.
Single chassis
configuration
If you have a single analog chassis, install a cable (PN 056-027-101) from a
Series 498 host computer serial port (debug) to J41 Com In on the Model 407.05
Hydraulic Control Panel, then from J42 Com Out to J41 Com In on the Model
497.01 Analog Chassis.
Multichassis
configuration
If you have a multiple analog chassis:
1. Install a cable from a Series 498 host computer serial port (debug) to J41
Com In on the Model 497.05 Hydraulic Control Panel, then from J42 Com
Out to J41 Com In on the first Model 497.01 Analog Chassis.
2. Install a chassis interconnect cable (PN 046-350-902) from J42 Com Out of
the first Model 497.01 Analog Chassis to J41 Com In of the next analog
chassis. Install as many cables as needed to connect all the chassis.
J43 and J44
These connectors are not used.
J51 and J52 Rear panel interlock connectors J51 Intlk In and J52 Intlk Out are associated
with the interlock controller module installed in slot A. Each connector handles
up to four test stations.