MTS Model FlexTest SE - Manual (Page 249)

Independent HSM with HPU (First On-Last Off)
Models FlexTest® IIm/GT/SE Controller Hardware Hydraulic Configurations 249
Independent HSM with HPU (First On-Last Off)
Note This interconnect option is only available for controllers on the same
interlock.
For this controller configuration:
• Two or more FlexTest SE Controllers are connected.
• An HSM is connected to each controller only.
• Select Auto. HPU/HSM for Power Type on the controller to which both a
HSM and HPU is connected.
Path: Config > Edit Hardware > Power Options > Power Type > Auto.
HPU/HSM
• Select HSM Only for Power Type on controllers with an independent HSM,
but no HPU.
Note The HPU can be connected to any controller in the interconnected group
of controllers.
FlexTest SE
Emergency Stop
7 8 9
6
5 4
3 2 1
. 0 +/-
enter
cancel
FG
Setup Status
Scope Meters
Tuning Config Limits
Log Menu ?
A B Recall
Enabled reset
Rewind Run Hold Stop
Power
Program
Hydraulic Interlock Program Interlock
HPU
HSM
Off Low High
Off Low High Navigate Monitor 1 Monitor 2
FlexTest SE
Emergency Stop
7 8 9
6
5 4
3 2 1
. 0 +/-
enter
cancel
FG Setup
Status Scope
Meters Tuning
Config Limits Log Menu ?
A B Recall
Enabled reset
Rewind Run Hold Stop
Power
Program Hydraulic Interlock Program Interlock
HPU
HSM
Off Low High
Off Low High Navigate Monitor 1 Monitor 2
Power Type = HSM Only
Interlock/Hydraulics
HPU HSM 1
056-126-4xx
J28 HSM
J25 HPU
039-713-7xx
056-316-0xx
Power Type = Auto. HPU/HSM
HSM 2