Encoder connections, Encoder connections 121, I/o carrier module configuration – MTS Model FlexTest SE User Manual
Page 121
Advertising
Encoder Connections
Models FlexTest® IIm/GT/SE Controller Hardware
FlexTest GT Controller Connections
121
Encoder Connections
I/O Carrier module
configuration
For an ADDA configuration using an I/O Carrier module, each encoder requires
installation of a Model 493.47 Encoder Interface mezzanine card on the Model
493.40 I/O Carrier board. The I/O Carrier connector is based on the location of
the mezzanine card installed on the board of the I/O Carrier module.
J6 I/O
J7 I/O
493.40
I/O Carrier
J3 Service
Shunt Cal
J4 I/O
J5 I/O
m
Advertising
This manual is related to the following products: