MTS Model FlexTest SE - Manual (Page 211)

How to Enable and Run External Command Inputs
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest IIm Controller Connections 211
Task 1 Cable the controllers.
Cable the external programmer analog out connector to a Series 498 Input Filter
connector. Analog I/O connectors are located on the rear of the test processor
chassis.
Note If you cable the hardware before you create a station configuration file,
note the connector you use on the FlexTest IIm rear console.
Task 2 Allocate external command resources in Station
Builder.
Using the Station Builder application, allocate controller resources to receive
programming from an external controller.
For more information, see “Enabling External Command Inputs” in the MTS 793
Control Software manual.
J11
(CH 1-4)
J12
(CH 5-8)
498
INPUT FILTER
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
498 Input Filter
This module includes 8 BNC
connectors that provide filtered
analog inputs to the 498.65
ADDA module.
Four analog inputs are available
with the standard ADDA module.
The other four inputs require a
second ADDA module.