Encoder connections, Encoder connections 121, I/o carrier module configuration – MTS Model FlexTest SE User Manual

Page 121

Text mode
Original mode

Advertising

Encoder Connections

Models FlexTest® IIm/GT/SE Controller Hardware

FlexTest GT Controller Connections

121

Encoder Connections

I/O Carrier module

configuration

For an ADDA configuration using an I/O Carrier module, each encoder requires
installation of a Model 493.47 Encoder Interface mezzanine card on the Model
493.40 I/O Carrier board. The I/O Carrier connector is based on the location of
the mezzanine card installed on the board of the I/O Carrier module.

J6 I/O

J7 I/O

493.40

I/O Carrier

J3 Service

Shunt Cal

J4 I/O

J5 I/O