MTS Model FlexTest SE - Manual (Page 171)

How to Send Signals to External Readout Devices
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest GT Controller Connections 171
How to Send Signals to External Readout Devices
1. Cable your controller to the readout device.
Cable your FlexTest IIm analog output connector to the readout device.
Analog I/O connectors are located on the rear of the test processor chassis.
Connect an external readout device analog input to a BNC connector on a
Model 493.76 Analog Out module.
2. Create a readout channel with Station Builder.
3. Adjust the readout signal in Station Manager.
Use Station Manager to adjust the readout signal.
493.76
Analog Out
Analog Monitor
From
I/O Carrier
Module