MTS Model FlexTest SE - Manual (Page 229)

Workstation Connection
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest SE Controller Connections 229
Workstation Connection
The workstation computer is connected to the processor module installed in the
VMEbus of the chassis. It is an Ethernet 10/100 Base-T connection. The
workstation computer must have an Ethernet compatible connector.
The symbol shown here indicates that you must not connect
telecommunications equipment to the equipment showing this symbol.
Several modules have connectors that look similar to a phone connector. Special
cables are required. Installing telecommunications equipment cables can cause
equipment damage to the electrical components of the chassis or to your
telecommunications system.
Service Connection
See “I/O Carrier service” on page 150.
ABT RST
TYPE E PC-MIP TYPE E PC-MIP
RUN 6TS BFL
DEBUG PCI MEZZANNE CARD
CAUTION