MTS Model FlexTest SE - Manual (Page 42)

Models FlexTest® IIm/GT/SE Controller Hardware
Installing the Plug-in Modules
Installation 42
Installing the Plug-in Modules
This section describes how to install the plug-in modules into the chassis. The
modules plug into a backplane connector and are secured to the chassis with a
screw at the top and at the bottom of the module faceplate.
A hardware interface file (.hwi file extension) defines each type of module and
maps each module location for the system software. The .hwi file and the
physical locations for each type of module must match. Recommended standard
module locations are described in the following sections. For more information
on the .hwi file, see the Hwi File Editor manual.
The plug-in modules contain static-sensitive components.
Improper handling of the module can cause component damage.
Be sure to follow these precautions when handling modules:
• Turn off electrical power before installing or removing a module.
• Use a static ground strap to ground yourself to the chassis ground
before touching the chassis or a module.
• Keep unused modules in conductive bags. Also be sure you are
grounded when removing a module from a conductive bag.
• Handle modules with their front panel or circuit card edges. Do not
touch any circuit card components, pins, or circuit connection points.
CAUTION