MacDon PW8 Pick-Up Header - Manual (Page 102)

MAINTENANCE AND SERVICING
4. Remove nut (A) securing support (B) to endshield (C),
and move support (B) off the bolt.
Figure 4.14
5. Swing endshield (A) fully back and loosen nuts (B)
on clips (C) at back of endshield so that clips can
disengage slots in header frame.
6. Move endshield (A) away from header.
Figure 4.15
4.5.2 Installing LH Endshield
1. Hold endshield (A) up to frame and insert clips (C) into
slots in header frame.
2. Tighten nuts (B) on clips (C) just enough to hold
endshield in place .
Figure 4.16: Attaching Endshield
169489
94
Revision A