6drives, 1header driveshaft, 2header driveline – MacDon PW8 Pick-Up Header User Manual
Page 105: Removing header driveline, Drives, Header driveshaft, Header driveline, 6 drives, 1 header driveshaft, 2 header driveline
4.6
Drives
4.6.1
Header Driveshaft
Clean and grease the header driveshaft splines annually to
prevent excessive corrosion and wear.
Figure 4.21
4.6.2
Header Driveline
Removing Header Driveline
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower header to ground, shut down combine, and
remove key from ignition.
2. Disconnect tethers (A) that secure driveline guard to
header.
3. Pull back the guard (B) to expose the collar (C) at the
combine end of driveline.
CAUTION
To prevent injury, or damage to the driveline, hold the
driveline so that it doesn’t fall to the floor.
4. Pull back collar (C), and pull driveline (D) off feeder
house shaft. Support end of driveline.
Figure 4.22: Combine End
169489
97
Revision A