MacDon PW8 Pick-Up Header - Manual (Page 75)

OPERATION
4. Position crop deflector (A) onto header endsheet as
shown and install with two M12x25 bolts (B) and nuts
provided in bag. Bolt heads must face inboard.
5. Repeat above step for opposite deflector.
Figure 3.83: Installing Deflector
Removing Crop Deflectors
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower the hold-down.
2. Lower header to the ground, shut down combine and
remove key from ignition.
3. Remove crop deflectors (A) by removing bolts (B).
4. Store deflectors and hardware in combine cab or an
alternate safe location.
Figure 3.84
169489
67
Revision A