MacDon PW8 Pick-Up Header - Manual (Page 124)

MAINTENANCE AND SERVICING
2. Open left endshield (A). Refer to Section: 3.3.1
Opening LH Endshield, page 25 .
Figure 4.66
3. Loosen the two clamp nuts (A) with a 24 mm wrench,
so that arm can move.
4. Loosen jam nut (B) on adjuster bolt.
5. Turn adjuster bolt (C) to adjust chain tension.
NOTE: Remove the plug from access hole in endsheet for
better access to adjuster bolt (C).
6. Tighten jam nut (B) and clamp nuts (A). Torque clamp
nuts (A) to 155 lbf·ft (210 N·m).
7. Close endshield. Refer to Section: 3.3.2 Closing LH
Endshield, page 26 .
Figure 4.67
169489
116
Revision A