2replacing hold-down hydraulic cylinders, Replacing hold-down hydraulic cylinders, 2 replacing hold-down hydraulic cylinders – MacDon PW8 Pick-Up Header User Manual
Page 160
Advertising
5. Tighten nuts (B) and (C).
Figure 4.149
6. For remaining rods (A), loosen adjacent nuts (B), and
repeat Step
4., Replacing Fiberglass Rods, page 151
7. Tighten nuts (B).
Figure 4.150
4.9.2
Replacing Hold-Down Hydraulic Cylinders
The hold-down is raised and lowered by two single acting hydraulic cylinders.
The operation of the cylinders can be adversely affected by air in the system or failure of the seals in the cylinders,
in which case the cylinders need to be removed and repaired, or replaced.
169489
152
Revision A
Advertising