MacDon PW8 Pick-Up Header - Manual (Page 166)

MAINTENANCE AND SERVICING
3. Position rod end of cylinder (F) and safety prop (G)
into cylinder support bracket on pick-up. Secure with
the shorter clevis pin (D), head faces outboard. Install
washer (B) and cotter pin (A).
4. Lift hold-down arm so that clevis pin (C) can be
installed through lift arm and barrel end of cylinder.
Head faces inboard.
Secure with washer (B) and
cotter pin (A).
5. Remove previously inserted block of wood.
6. Bleed cylinders and lines. Refer to Section: Bleeding
Cylinders and Lines, page 159
Figure 4.164
169489
158
Revision A