MacDon PW8 Pick-Up Header - Manual (Page 138)

MAINTENANCE AND SERVICING
3. If installing end belt (A), attach edge protector (B), and
secure with M6 flange nuts (C). Do not tighten.
4. Tighten M6 flange nuts to 35–45 lbf·in (4–5 N·m).
Figure 4.98
5. Install connector bar(s) (A) onto bolts, and secure with
M6 flange nuts (B).
6. Tighten M6 flange nuts (B) to 35–45 lbf·in (4–5 N·m).
Figure 4.99
7. Install square neck elevator bolts at strap locations.
Use M6x16 bolt (A) at center location, and M6x23
bolt (B) at finger locations.
8. Install straps (C) and fingers (D) onto bolts, and secure
with M6 flange nuts (E).
9. Torque nuts to 45–60 lbf·in (5.0–6.8 N·m).
10. Tension draper belts. Refer to Section Adjusting
Draper Belt Tension on Front Deck, page 69 .
Figure 4.100
169489
130
Revision A