MacDon PW8 Pick-Up Header - Manual (Page 151)

MAINTENANCE AND SERVICING
13. Line up new bearing (A) with slots in bearing support,
and push bearing into bearing support.
14. Swivel bearing 90 degrees so that it slides into groove
inside bearing support.
Figure 4.130
15. If replacing bushing (A), remove bushing and install
new bushing (A).
Figure 4.131: Left Side Shown - Right Side
Opposite
16. Place bearing support (B) on roller shaft (A).
17. Locate base of bearing support against frame, and
align mounting holes.
18. Install two M12x30 carriage bolts (C) in the upper holes
and two M12x40 carriage bolts (D) in the lower holes.
Secure with lock nuts.
NOTE: Ensure height controller is not damaged when
installing bolts.
Figure 4.132
169489
143
Revision A