MacDon PW8 Pick-Up Header User Manual
Page 128
Advertising
1. Lower header to ground, shut down combine, and
remove key from ignition.
2. Open endshield. Refer to Section
3. Remove chain (D). Refer to
4. Remove cotter pin (A).
Figure 4.75
5. If header is not attached to combine, place a pry bar
or equivalent through a hole in the large sprocket and
against the frame to stop the driveshaft from rotating.
Figure 4.76
6. Remove M20 castle nut (B), and washer (C) from
driveshaft.
Figure 4.77
169489
120
Revision A
Advertising