Installing drive sprocket – MacDon PW8 Pick-Up Header User Manual
Page 129
Advertising
7. Remove the sprocket (A). Use a puller if necessary.
8. Clean and inspect components.
Replace worn or
damaged parts.
Figure 4.78
Installing Drive Sprocket
1. Apply
a
coating
of
anti-seize
compound
to
driveshaft (B) and sprocket (A) splines.
Figure 4.79
2. Install sprocket (A), washer (B), and castle nut (C) onto
driveshaft.
3. Reinstall drive chain, but do not fully tension. Refer to
Installing Auger Drive Chain, page 115
Figure 4.80
169489
121
Revision A
Advertising