MacDon PW8 Pick-Up Header - Manual (Page 109)

MAINTENANCE AND SERVICING
3. Remove the cross and bearings (A) connecting the
clutch (B) to the driveline yoke (C).
4. Install new bearings and cross (A), and clutch (B) onto
existing driveline yoke (C).
Figure 4.28
5. Re-install the guard (A). Refer to Installing Driveline
Guard, page 103 .
6. Re-install driveline. See Section Installing Header
Driveline, page 99 .
Driveline Guard
Removing Driveline Guard
The main driveline guard normally remains attached to the driveline, but can be removed for maintenance.
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
NOTE: The driveline does NOT need to be removed from the header in order to remove the driveline guard.
To remove a main driveline guard, follow these steps:
1. Disconnect tethers (not shown) at ends of driveline.
2. Rotate disc (B) on driveline storage hook (A), and
remove driveline from hook.
Figure 4.29
169489
101
Revision A