MacDon PW8 Pick-Up Header - Manual (Page 89)

MAINTENANCE AND SERVICING
O-Ring Boss (ORB) Hydraulic Fittings (Adjustable)
1. Inspect O-ring (A) and seat (B) for dirt or obvious
defects.
2. Back off the lock nut (C) as far as possible. Ensure that
washer (D) is not loose and is pushed toward the lock
nut (C) as far as possible.
3. Check that O-ring (A) is not on the threads, adjust
if necessary.
4. Apply hydraulic system oil to the O-ring (A).
Figure 4.4
A - O-Ring B - Seat C - Nut
D - Washer
5. Install fitting (B) into port until back up washer (D) and
O-ring (A) contacts on part face (E).
6. Position angle fittings by unscrewing no more than
one turn.
7. Turn lock nut (C) down to washer (D) and tighten to
torque shown. Use two wrenches, one on the fitting
(B) and the other on the lock nut (C).
8. Check the final condition of the fitting.
Figure 4.5
A - O-Ring B - Fitting C - Nut
D - Washer E - Part Face
169489
81
Revision A