MacDon PW8 Pick-Up Header User Manual
Page 130
Advertising
4. If header is not attached to combine, place a pry bar
or equivalent through a hole in the large sprocket and
against the frame to stop the driveshaft from rotating.
Figure 4.81
5. Torque castle nut (B) to 50 lbf·ft (68 N·m).
6. Install cotter pin (A) into driveshaft. If slot in castle nut
(B) and hole in driveshaft are not aligned, tighten castle
nut (B) until cotter pin can be installed. Do NOT loosen
castle nut.
7. Bend cotter pin (A) around castle nut (B).
8. Set drive chain (D) tension. Refer to
Figure 4.82
9. Close endshield. Refer to
.
169489
122
Revision A
Advertising