MacDon PW8 Pick-Up Header - Manual (Page 103)

MAINTENANCE AND SERVICING
3. Close shield (A), ensuring that magnet (B) and stop (C)
in header frame are aligned. This will ensure that the
latch (D) will line up with the receptacle (E).
NOTE: Latch (D) and magnet (B) positions are properly
adjusted at the factory.
4. If required, loosen nuts on clips at the back of the shield
(A) and reposition the shield. Tighten the nuts but do
not overtighten to prevent damage to the shield.
Figure 4.17: Aligning Shield
5. Open endshield (C) slightly so that support (B) can
be installed onto endshield. Check that washer (D) is
between the support and the endshield.
6. Install nut (A) and leave 5/16–3/8 in. (8–10 mm)
gap between washer (D) and nut (A) for support (B)
to move.
Figure 4.18: Attaching Support
7. Close the shield and turn latch (A) clockwise until
it stops (slightly more than one-half turn) using a
standard end screwdriver.
8. Check that magnet (B) on endshield is against the
header endsheet and that latch (A) is engaged.
Figure 4.19: Endshield Closed
4.5.3 Replacing Endshield Brackets
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
169489
95
Revision A