MacDon PW8 Pick-Up Header - Manual (Page 179)

MAINTENANCE AND SERVICING
4.13 Lights
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
Use electrical tape and wire clips as required to prevent wires from dragging or rubbing.
Keep lights clean, and replace defective bulbs.
If light housing is cracked or broken, it should be replaced.
4.13.1 Adjusting Transport Lights
The transport lights are located at each end of the header, and are used when driving the combine on the road with
the header attached. They should be positioned perpendicular to the endsheet. If they require repositioning, swivel
the lights to the correct position with hand force.
1. If the swivel is too loose or too tight, loosen jam nut
(A), and turn nut (B) so that the light maintains its
position and can be moved with hand force. Do not
over-tighten.
2. Tighten jam nut (A).
Figure 4.189: Transport Light
169489
171
Revision A