MacDon PW8 Pick-Up Header - Manual (Page 132)

MAINTENANCE AND SERVICING
8. Install access cover (B) with screws coated with
Loctite ® . Torque screws to 75 lbf·in (8.5 N·m).
Figure 4.85
4.7.2 Replacing Auger Finger Guides
1. Raise the hold-down fully, and engage lift cylinder
safety props.
DANGER
Stop engine and remove key from ignition before
leaving operator’s seat for any reason. A child or
even a pet could engage an idling machine.
2. Stop engine, and remove key from ignition.
3. Remove two screws (A) from access cover (B) closest
to the guide being replaced, and remove access cover.
4. Remove finger. Refer to Section: 4.7.1 Replacing
Auger Fingers, page 123 .
Figure 4.86
169489
124
Revision A