MacDon PW8 Pick-Up Header - Manual (Page 162)

MAINTENANCE AND SERVICING
8. Remove clevis pin (A) at rod end of cylinder, and
remove cylinder and safety prop (B).
Figure 4.153
9. Cut cable ties on hoses (A) and (B), and disconnect
hoses from cylinder. Install caps onto hose ends, or
wrap with plastic.
Figure 4.154
Installing Master Cylinder
1. If installing new master cylinder:
a. Remove the two 90 degree elbows (A) and (B) from
the old cylinder.
b. Remove plugs from new cylinder ports.
c. Install elbows (A) and (B) onto new cylinder as
shown (C). Tighten jam nuts on elbows.
Figure 4.155
169489
154
Revision A