MacDon PW8 Pick-Up Header User Manual
Page 52
Advertising
![background image](/manuals/570572/52/background.png)
13. Pull handle (A) to full horizontal position as shown to
fully engage coupler, and to extend pins (B) at base of
feeder house into the locking plates (C). Knob (D) will
engage handle to lock handle.
Figure 3.36: Locking Feederhouse
NOTE:
If handle does not move to full horizontal position,
check alignment of locking plates (A) on the
header with locking pins (B) on both sides of the
feeder house. If necessary, loosen nuts (C), and
adjust plates (A) to line up with pins (B). Retighten
nuts.
Figure 3.37: Aligning Locking Plates
169489
44
Revision A
Advertising