MacDon PW8 Pick-Up Header - Manual (Page 68)

OPERATION
6. Close endshield (A). Refer to Section: 3.3.2 Closing
LH Endshield, page 26 .
Figure 3.69
Unlocking Auger Float
Unlock auger float as follows:
DANGER
Stop engine and remove key from ignition before
leaving operator’s seat for any reason. A child or
even a pet could engage an idling machine.
1. Lower header to the ground, shut down combine and
remove key from ignition.
2. Open left endshield (A). Refer to Section: 3.3.1
Opening LH Endshield, page 25 .
Figure 3.70
3. Loosen the two bolts (A) on auger upstops (B) on both
ends of header.
4. Slide stops (C) upward to desired float range.
5. Tighten bolts (A).
6. Close left endshield. Refer to section: 3.3.2 Closing
LH Endshield, page 26 .
Figure 3.71: Left End
169489
60
Revision A