MacDon PW8 Pick-Up Header - Manual (Page 43)

OPERATION
2. Slowly drive combine up to header until feeder house
saddle (A) is directly under the header top cross
member.
3. Raise feeder house slightly to lift header, ensuring
feeder saddle is properly engaged in header frame.
WARNING
Stop combine engine and remove key before making
adjustments to machine. A child or even a pet could
engage the drive.
4. Stop engine, and remove key from ignition.
Figure 3.12: Header on Combine
5. Lift lever (A) on header at left side of feeder house,
and push handle (B) on combine to engage locks (C)
on both sides of the feeder house.
6. Push down on lever (A) so that slot in lever engages
handle (B) to lock handle in place.
7. If locks (C) do not fully engage pins (D) on header,
loosen nut (E), and adjust position of pin (D) as
necessary (both sides). Tighten nut.
8. To obtain full lock on pin (D) when (A) and (B) are
engaged, loosen bolts (F), and adjust lock as required.
Retighten bolts.
Figure 3.13: Engaging Locks
169489
35
Revision A