MacDon PW8 Pick-Up Header - Manual (Page 143)

MAINTENANCE AND SERVICING
4. Remove the M6 flange nut (A) and washer (B)
attaching the guide (C) to the draper belt (D). If guide
is under a finger (E), remove the finger.
5. Loosen draper belt as much as possible.
6. From under the deck, pull the draper belt away from
the frame to expose the guide (C).
7. Remove the guide (C) and elevator bolt (F). Discard
the old guide.
8. Place a new guide (C) onto the M6x26 elevator bolt (F),
and install onto the draper belt (D).
9. Install M6 washer (B) and flange nut (A).
Figure 4.109
10. If guide is in a finger location, use an M6x30 elevator
bolt (A), and install the finger (B) BEFORE installing
the flange nut (C).
11. Torque nut (C). Hold the finger or guide from turning
while tightening nut.
a. For guide only location, torque nut (C)
to 35–45 lbf·in (4–5 N·m).
b. For guide and finger location, torque nut to
45–60 lbf·in (5–6.5 N·m).
IMPORTANT:
Ensure guides (D) are perpendicular to direction
of travel.
12. Manually rotate draper belt to access all the guides.
13. Retighten draper belt.
Figure 4.110
169489
135
Revision A