Installing front hydraulic motor – MacDon PW8 Pick-Up Header User Manual
Page 114
Advertising
1. Lower pick-up to ground, shut down combine, and
remove key from ignition.
2. Disconnect hydraulic hoses (A) from motor. Install
caps onto hose ends, or wrap with plastic and move
hoses away from work area.
3. Remove two nuts (B) with a 16 mm socket.
Figure 4.39
4. Pull hydraulic motor (A) from roller shaft.
Figure 4.40
Installing Front Hydraulic Motor
1. Apply general purpose grease to hydraulic motor (A)
shaft splines.
2. Install motor onto roller shaft (B) and shoulder bolts (C).
Figure 4.41
169489
106
Revision A
Advertising