MacDon PW8 Pick-Up Header - Manual (Page 139)

MAINTENANCE AND SERVICING
Removing Rear Draper Belt
1. Raise the hold-down fully, and engage lift cylinder
safety props.
2. Raise the header fully, and engage the combine lift
cylinder stops.
DANGER
Stop engine and remove key from ignition before
leaving operator’s seat for any reason. A child or
even a pet could engage an idling machine.
3. Stop engine, and remove key from ignition.
4. Fully release draper belt tension. Refer to Section
Adjusting Draper Belt Tension on Rear Deck, page 69 .
5. If removing end belt, remove seven M6 flange nuts (A),
belt edge protector (B), and associated pronged
elevator bolts (C) in the belt (D) to be removed.
Figure 4.101
6. Remove M6 flange nuts (A), connector bar (B),
and pronged elevator bolts (C) in the belt (D) to be
removed.
Figure 4.102
169489
131
Revision A