MacDon PW8 Pick-Up Header - Manual (Page 181)

MAINTENANCE AND SERVICING
4.13.4 Replacing Lamp Housing
If light housing is cracked or broken, it should be replaced.
1. Lower header to the ground, shut off combine, and
remove key from ignition.
2. Pull wiring harness (A) out of lamp bracket, and locate
connectors inside the wiring harness.
3. Disconnect light wiring from harness.
4. Remove four nuts (B), and remove lamp (C) from
bracket.
5. Install new lamp (C) on bracket, and secure with four
nuts (B).
6. Connect lamp wiring to harness (A), and route wires
inside plastic covering. Seal with black tape.
7. Check wiring harness is not damaged, and secure
harness inside lamp bracket.
8. Check operation of new lamp.
Figure 4.192
169489
173
Revision A