MacDon PW8 Pick-Up Header User Manual
Page 176
Advertising
3. Replace draper speed sensor as follows:
a. Remove lower jam nut (A), and pull sensor (B) from
support (C).
b. Disconnect sensor (B) from harness, and remove
top jam nut (D).
c. Attach new sensor (B) to harness, and install top
jam nut (D) onto sensor.
d. Locate sensor (B) in support (C), and secure with
lower jam nut (A).
e. Adjust clearance between sensor and sensor disc.
Refer to Section:
Figure 4.185
169489
168
Revision A
Advertising