Adjusting auger position, Danger – MacDon PW8 Pick-Up Header User Manual
Page 65
Advertising
The clearance (A) between the auger fingers (B) and pan
(C) should be 13/16–1 in. (20–25 mm).
Figure 3.62: Finger to Pan Clearance
Adjusting Auger Position
If adjustments are required, proceed as follows:
NOTE:
Both ends of the auger are adjustable to maintain a uniform clearance across the width of the
header.
NOTE:
Access the auger/pan area from top of header.
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower header to the ground, shut down combine and
remove key from ignition.
2. Open endshield (A) on left end of header. Refer to
Section:
3.3.1 Opening LH Endshield, page 25
.
Figure 3.63
169489
57
Revision A
Advertising