Installing auger drive chain, Adjusting auger drive chain tension, Danger – MacDon PW8 Pick-Up Header User Manual
Page 123
3. Release tension on chain (A) until chain can be
removed from small sprocket (B). Refer to
Auger Drive Chain Tension, page 115
4. Remove chain from large sprocket (C).
Figure 4.63
Installing Auger Drive Chain
1. Install chain (A) onto large sprocket (C), and then onto
small sprocket (B).
2. Tighten chain. Refer to
.
3. Liberally apply SAE Multi-Purpose Grease to chain.
4. Close endshield. Refer to Section:
.
Figure 4.64
Adjusting Auger Drive Chain Tension
The drive chain tension is set at the factory, and should be checked after three hours of operation, and at regular
intervals thereafter.
There should be 1/2–3/4 in. (13–19 mm) of deflection (A)
with 10 lbf (44.5 N) force applied at mid-span.
DANGER
Stop engine and remove key from ignition before
leaving operator’s seat for any reason. A child or
even a pet could engage an idling machine.
1. Lower header to ground, shut down combine, and
remove key from ignition.
Figure 4.65: Chain Deflection
169489
115
Revision A