MacDon PW8 Pick-Up Header - Manual (Page 135)

MAINTENANCE AND SERVICING
4.7.4 Replacing Flighting Extensions
With header removed from combine, proceed as follows:
1. Remove the auger hand hole cover on either side of
the center cover.
Figure 4.91: View From Top
2. Remove hardware (B) and (C) securing existing auger
flighting extension (A) to auger, and remove extension.
3. Place new flighting (A) on auger, ensuring new flighting
locates on the outboard side of the existing flighting.
4. Use the existing hardware (B) and (C) to secure
flighting to auger. Bolts (B) must be installed with nuts
facing outboard as shown.
Figure 4.92: Right Extension Shown
NOTE: To replace original flighting, refer to the PW8
Pick-Up Header Technical Manual MD #169841,
or see your MacDon Dealer.
169489
127
Revision A