MacDon PW8 Pick-Up Header - Manual (Page 134)

MAINTENANCE AND SERVICING
4.7.3 Replacing Stripper Plates
The stripper plates should be replaced if they are worn to the point where the specified clearance cannot be
maintained. Replace missing or damaged fasteners as well.
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower header to the ground, shut down combine, and
remove key from ignition.
NOTE: Access the auger/stripper plate area from top of
header.
2. Remove bolts (A) on the stripper plate (B) to be
replaced.
3. Replace plate (B), and secure with bolts (A), but do not
fully tighten.
4. Adjust stripper plate to achieve 1/8–1/4 in. (3–6 mm)
clearance (C) to auger flighting.
5. Tighten nuts.
6. Recheck the clearance.
Figure 4.90: Stripper Plate Clearance
169489
126
Revision A