Rockwell Automation 198 Series C Modular DeviceNet Starter Auxiliary User Manual - Manual (Page 56)

4-9 Programming
Publication 198-UM002A-EN-P December 2001
You will then be asked to enter a name for your driver choose a name and select 2.. The
following screen will appear:
In the above screen, configure your driver to the appropriate parameters for your system. For
this example we will be using an SLC and select “SLC-CHO/Micro/Panelview” under the
'HYLFH pull down tab.
After selecting the proper device, press the
$XWR&RQILJXUH button to find an acceptable
baud rate. When Auto-Configure is completed you will see a message that says the
Auto-Configuration was successful. Once you have seen this message, click the
2. button.