Rockwell Automation 198 Series C Modular DeviceNet Starter Auxiliary User Manual - Manual (Page 58)

4-11 Programming
Publication 198-UM002A-EN-P December 2001
Now that you have configured a driver, you can launch RSLogix 500 to begin programming.
In RSLogix you will be able to write explicit messages in SLC ladder logic. You will also be
able to monitor our input and output bits.
To begin, click “new” under the file menu. You will be prompted to select the type of
processor that you would like to use. Select the appropriate processor and click
2..
Next you will have to configure the I/O. Double click on ,2 &RQILJXUDWLRQ under the
&RQWUROOHU folder on the left panel of the screen. The following screen will be displayed:
You can see from the above screen that the process card is the only slot recognized. To
acknowledge other cards in your system, highlight the appropriate card in the “current cards
available” field and drag it over into the desired slot in the lower left window. The module will
now be recognized.