Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 136)

3-62 Operator Interface
7000A-RM001A-EN-P – January 2011 7000 “A” Frame
The screen will then ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. Performing a format will
overwrite all existing data on the flash card.
Formatting can take up to several minutes depending on the card
involved. The status will indicate when the formatting is complete
or if an error occurred.
Additional cards may be formatted from this screen by pressing the
[F2] key.
View a Directory
The directory of a flashcard is shown by pressing the [F7] key on the
TRANSFER screen. The directory shows the filename and
extension, along with a date and time stamp of when the file was
created. A screen typical of Figure 3.89 will be shown.
Figure 3.89 – Typical Directory
Any screen or operation that requires a filename to be entered or
picked from the directory uses this DIRECTORY screen. It is
always obtainable from the [F7] key on any applicable screen.
When the directory is entered from the TRANSFER screen, all files
will be shown. When entered from one of the operations screens,
only the files that are relevant to the operation being performed will
be shown.
Only the root directory of the card is used, as sub directories are not
supported in the operator interface.